Removal Procedure

NOTE: Secure the steering wheel utilizing a strap to prevent rotation. Locking of the steering column will prevent damage and a possible malfunction of the SIR system. The steering wheel must be secured in position before disconnecting the following components:

The steering column
The intermediate shaft
The steering gear

After disconnecting these components, do not move the front tires and wheels. Failure to follow these procedures may cause improper alignment of some components during installation and result in possible damage to the SIR coil.

Remove the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
Remove the knee bolster. Refer to Knee Bolster Replacement .
Remove the instrument panel cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
Remove the steering column opening filler bolts. Refer to Steering Column Opening Filler Replacement .
Disconnect all electrical connectors as needed.

Fig 1: Identifying Steering Column Lower Support Brace

Courtesy of GENERAL MOTORS CORP.

If equipped, remove the steering column lower support brace bolts (1) and steering column lower support brace (2).

Fig 2: Identifying Intermediate Steering Shaft

Courtesy of GENERAL MOTORS CORP.

Remove the intermediate steering shaft bolt (1) at the steering column and separate the intermediate steering shaft (2). Do not pull the intermediate steering shaft upper seal (3) from its place.

Fig 3: Identifying Steering Column Nuts And Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the steering column nuts (2) and the steering column bolts (1).
Remove the steering column from the vehicle.
Transfer any parts as needed.