Digital Radio Receiver Replacement

WARNING: This page is about a different car, the 2008 Saturn Outlook, 2008 GMC Acadia, and 2008 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Digital Radio Receiver

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the left rear quarter lower trim panel. Refer to Rear Quarter Lower Trim Panel Replacement (Acadia/OUTLOOK with E61) or Rear Quarter Lower Trim Panel Replacement (Acadia/OUTLOOK without E61) or Rear Quarter Lower Trim Panel Replacement (Enclave with E61) or Rear Quarter Lower Trim Panel Replacement (Enclave without E61) . Remove the liftgate close actuator bracket (if equipped). Refer to Liftgate Close Actuator Bracket Replacement .
1	Communication Interface Module Bracket Procedure: Disconnect the electrical connectors.
2	Digital Radio Receiver Procedure: Refer to Control Module References for programming and set up information. Tip: Pull tab to release the receiver.

Callout

Component Name

Preliminary Procedures

Remove the left rear quarter lower trim panel. Refer to Rear Quarter Lower Trim Panel Replacement (Acadia/OUTLOOK with E61) or Rear Quarter Lower Trim Panel Replacement (Acadia/OUTLOOK without E61) or Rear Quarter Lower Trim Panel Replacement (Enclave with E61) or Rear Quarter Lower Trim Panel Replacement (Enclave without E61) .
Remove the liftgate close actuator bracket (if equipped). Refer to Liftgate Close Actuator Bracket Replacement .

Communication Interface Module Bracket
Procedure:
Disconnect the electrical connectors.

Digital Radio Receiver
Procedure:
Refer to Control Module References for programming and set up information.
Tip: Pull tab to release the receiver.