LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2007 >> Acadia SLT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 393 (Power Door Lock System And Release Systems) >> Repair Instructions >> Door Latch Release Switch Replacement - Driver Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac XLR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Door Latch Release Switch
    GM1271087Courtesy of GENERAL MOTORS CORP.
  1. Install the door latch release switch to the armrest trim cover applique.
    2. Fig 2: View Of Armrest Pull Trim Cover & Trim Cover Applique
    GM1271409Courtesy of GENERAL MOTORS CORP.
  2. Install the applique to the armrest.
    3. NOTE: Refer to Fastener Notice .
  3. Install the retaining screws to the trim cover applique.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  4. Install the trim cover to the armrest. Push on the armrest to engage the retainers.
    5. Fig 3: View Of Armrest Assembly & Screws
    GM1271088Courtesy of GENERAL MOTORS CORP.
  5. Connect the wire harness to the door armrest assembly.
  6. Install the armrest to the door trim panel. Secure the armrest with 4 retaining screws at the rear and 1 screw at the forward end of the armrest assembly.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

    7. Fig 4: View Of Door Panel Inner Energy Absorber
    GM1272532Courtesy of GENERAL MOTORS CORP.
  7. Install the inner energy absorber to the door panel.
  8. Install the door trim panel. Refer to Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals