LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2007 >> Acadia SLT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1243 (Engine Controls/Fuel - 6.2L - Repair Instructions) >> Repair Instructions >> Knock Sensor 2 Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2013 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Knock Sensor, Starter Assembly, Engine Electrical Connector & Engine Block - Right Side
    GM1480896Courtesy of GENERAL MOTORS COMPANY
  1. Reconnect electrical connector (3) for the engine harness to the knock sensor (2).
  2. Position the knock sensor (2) on the engine block (5).
  3. Install the mounting bolt (1) for the knock sensor (2).
    4. CAUTION:

    Refer to Fastener Caution .

  4. Tighten the knock sensor mounting bolt (1) and tighten to 20 N.m (15 lb ft).
  5. Install the starter assembly (4), ONLY IF REMOVED. Refer to Starter Replacement (LSA) , Starter Replacement (LF1/LLT) .
  6. Install the right catalytic convertor. Refer to Catalytic Converter Replacement - Right Side (LFW,LFX) , Catalytic Converter Replacement - Right Side (LSA) .
  7. Install the right exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (LSA) .
scientia non olet · About LEMON Manuals