Radio Replacement (Enclave)

WARNING: This page is about a different car, the 2008 Saturn Outlook, 2008 GMC Acadia, and 2008 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Radio (Enclave)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Acadia) or Instrument Panel Accessory Trim Plate Replacement (Enclave) or Instrument Panel Accessory Trim Plate Replacement (Outlook) .
1	Radio Screw (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 2.5 N.m (22 lb in)
2	Radio Assembly Procedure Disconnect the electrical connector. Disconnect the antenna cable. Reprogram the radio after replacement. Refer to Control Module References . Tip: When installing the radio verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.

Callout

Component Name

Preliminary Procedure:
Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Acadia) or Instrument Panel Accessory Trim Plate Replacement (Enclave) or Instrument Panel Accessory Trim Plate Replacement (Outlook) .

Radio Screw (Qty: 4)

NOTE: Refer to Fastener Notice .

Tighten: 2.5 N.m (22 lb in)

Radio Assembly

Procedure

Disconnect the electrical connector.
Disconnect the antenna cable.
Reprogram the radio after replacement. Refer to Control Module References .

Tip: When installing the radio verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.