LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2007 >> Acadia SLE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Lighting Systems) >> Repair Instructions >> Brake Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac G6. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Brake Pedal Adjustment Position Sensor
    GM1238864Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Do not reuse the position sensor bolt. Always use a new bolt when installing a brake pedal position sensor.
  1. Install the brake pedal position sensor and the bolt to the brake pedal bracket.

    Tighten:  Tighten the bolt to 2 N.m (18 lb in).

  2. Install the electrical connector to the position sensor.
  3. Install the steering wheel stub shaft to the steering column. Refer to Intermediate Steering Shaft Replacement in Steering Wheel and Column.
  4. Install the closeout panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
  5. Calibrate the position sensor. Refer to Brake Pedal Position Sensor Calibration .
scientia non olet · About LEMON Manuals