LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2007 >> Acadia SLE, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Starter Motor Replacement >> Installation Procedure

Installation Procedure

NOTE: Refer to Fastener Notice .
Fig 1: View Of Starter Bolts And Starter
GM1861149Courtesy of GENERAL MOTORS CORP.
  1. Install the starter and bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    2. Fig 2: Identifying Engine Wiring Harness Electrical Connector
    GM1860484Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (1) to the starter.
    3. Fig 3: View Of Battery Positive Junction Block Cable Clip And Battery Positive Junction Block Cable Terminal
    GM1861148Courtesy of GENERAL MOTORS CORP.
  3. Install the battery positive junction block cable terminal (2) to the starter.
  4. Install the starter solenoid BAT terminal nut (3).

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

    5. Fig 4: Identifying Starter Heat Shield Bolt And Shield
    GM1861146Courtesy of GENERAL MOTORS CORP.
  5. Install the starter heat shield and bolt.

    Tighten:  Tighten the bolt to 7 N.m (62 lb in).

  6. Install the left catalytic convertor. Refer to Catalytic Converter Replacement - Left Side .
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals