LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2007 >> Acadia SLE, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Replacement (Second Design) >> Removal Procedure

Removal Procedure

    Fig 1: Identifying Air Conditioning Liquid Line Clamp Bolt
    GM1861641Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the drive belt. Refer to Drive Belt Replacement .
  3. Remove the fuel injector sight shield. Refer to FUEL INJECTOR SIGHT SHIELD REPLACEMENT .
  4. Remove the engine mount strut bracket. Refer to ENGINE MOUNT STRUT BRACKET REPLACEMENT - RIGHT SIDE .
  5. Remove the air conditioning (A/C) liquid line clamp bolt (2) from the upper radiator support.
    Fig 2: Identifying Coolant Recovery Reservoir And Bolts
    GM1929511Courtesy of GENERAL MOTORS CORP.
  6. Remove the coolant recovery reservoir bolts (1).
  7. Remove the reservoir (2) tabs from the upper radiator support, position the reservoir out of the way.
    Fig 3: Identifying Battery Positive Junction Block Cable Boot And Battery Positive Junction Block Cable Terminal
    GM1861163Courtesy of GENERAL MOTORS CORP.
  8. Reposition the battery positive junction block cable boot (1).
  9. Remove the battery positive junction block cable to generator nut (2).
  10. Remove the battery positive junction block cable terminal (3) from the generator stud.
    Fig 4: Identifying Idler Pulley Bolt
    GM1929701Courtesy of GENERAL MOTORS CORP.
  11. Loosen the idler pulley bolt (1) and slide the pulley out as far as possible.
    Fig 5: View Of Power Steering Reservoir Inlet Hose Clip
    GM1929702Courtesy of GENERAL MOTORS CORP.
  12. Remove the power steering reservoir inlet hose clip (1) from the power steering fluid reservoir hose clip bracket (2).
    13. Fig 6: Identifying Idler Pulley Bolt
    GM1870243Courtesy of GENERAL MOTORS CORP.
  13. Loosen the idler pulley (1) bolt and slide the pulley out as far as possible.
    14. Fig 7: View Of Generator Bolts, A/C Compressor/Evaporator Hose Bracket And Generator
    GM1929703Courtesy of GENERAL MOTORS CORP.
  14. Remove the generator bolts (2).
  15. Remove the A/C compressor/evaporator hose bracket (1) from against the generator.
  16. Remove the power steering fluid reservoir hose clip bracket (3) from against the generator.
  17. Remove the generator (4) and idler pulley (5) together from the vehicle.
  18. Remove the idler pulley from the generator.
scientia non olet · About LEMON Manuals