LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> Electrical >> Starter >> Battery, Charging System And Starting System - Introduction >> Repair Instructions >> Generator Bracket Replacement (8.1L Engine) >> Installation Procedure

Installation Procedure

  1. Install the generator bracket.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the generator bracket stud.

    Tighten:  Tighten the stud to 20 N.m (15 lb ft).

    Fig 1: View Of Generator Bracket, Bolts, Nuts & Stud
    GM751458Courtesy of GENERAL MOTORS CORP.
  3. Install the generator bracket bolts and nut.

    Tighten:  Tighten the bolts and nut to 50 N.m (37 lb ft)

  4. Install the generator. Refer to Generator Replacement (4.8L, 5.3L, and 6.0L Engines)  or Generator Replacement (6.6L (LLY) Engine)  or Generator Replacement (8.1L Engine) .
  5. Install the drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement in Engine Mechanical - 8.1L.
  6. Install the fan and clutch. Refer to Fan Clutch Replacement (Diesel) or Fan Clutch Replacement (Gasoline) in Engine Cooling.
    7. Fig 2: View Of Battery Cable Junction Block Bracket Bolts (8.1L Engine)
    GM759640Courtesy of GENERAL MOTORS CORP.
  7. Install the battery cable junction block bracket bolts.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

scientia non olet · About LEMON Manuals