LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Envoy 5.3 M, RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 5.3L - Introduction (2 Of 2) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Throttle Body Assembly
    GM1401966Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW throttle body gasket (509).
  2. Install the throttle body (508).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the throttle body bolts (538) and nuts (507).

    Tighten:  Tighten the bolts/nuts to 6 N.m (53 lb in).

    4. Fig 2: View Of Auxiliary Heater Inlet & Outlet Hoses/Pipes
    GM901492Courtesy of GENERAL MOTORS CORP.
  4. Connect the 2 throttle body engine coolant hoses to the throttle body.
  5. Position the throttle body hose clamps.
    6. Fig 3: Throttle Actuator Motor Connector & Throttle Actuator Motor
    GM1522415Courtesy of GENERAL MOTORS CORP.
  6. Connect the throttle actuator motor electrical connector (1) to the throttle actuator motor (2).
    7. Fig 4: View Of Intake Air Tube
    GM898123Courtesy of GENERAL MOTORS CORP.
  7. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  8. Refill the cooling system. Refer to Draining and Filling Cooling System (LL8) or Draining and Filling Cooling System (LH6, LS2) in Engine Cooling.
  9. Verify that the vehicle meets the following conditions:
    • The vehicle is not in a reduced engine power mode.
    • The ignition is ON.
    • The engine is OFF.
  10. Connect a scan tool in order to test for a proper throttle-opening and throttle-closing range.
  11. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed throttle, and a wide open throttle (WOT).
  12. Start the engine.
  13. Inspect for coolant leaks.
scientia non olet · About LEMON Manuals