LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Controls - 6.6L (Introduction)) >> Repair Instructions >> Fuel Sender Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Using J 45722 To Remove/Install The Sending Unit Lock Ring
    GM1372817Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (Pickup)  or Fuel Tank Replacement (Cab/Chassis - Front)  or Fuel Tank Replacement (Cab/Chassis - Rear) .
  2. Disconnect the fuel lines from the sending unit. Refer to Quick Connect Fitting(s) Service (Metal Collar)  or Quick Connect Fitting(s) Service (Plastic Collar) .
  3. Using J 45722  , remove the sending unit lock ring.
    4. Fig 2: View Of Sending Unit And Seal
    GM1488784Courtesy of GENERAL MOTORS CORP.
  4. Remove the sending unit and seal. Discard the seal.
  5. Clean the sending unit sealing surfaces.
scientia non olet · About LEMON Manuals