LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Jimmy Part Time, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transmission - Introduction >> Repair Instructions >> Vehicle Speed Sensor (VSS) >> Installation Procedure

Installation Procedure

  1. Coat a new O-ring seal with a thin film of transmission oil.
    2. Fig 1: View Of Vehicle Speed Sensor
    GM761481Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the following parts:
    1. The O-ring on the vehicle speed sensor assembly.
    2. The vehicle speed sensor assembly.
    3. Tighten:  Tighten the bolt to 16 N.m (12 lb ft).
    3. Fig 2: Locating Electrical Connector For Vehicle Speed Sensor
    GM102878Courtesy of GENERAL MOTORS CORP.
  3. Install the electrical connector to the vehicle speed sensor.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals