Installation Procedure
- Connect the SIR electrical connector.
- Connect the CPA retainer to the SIR connector.
- Install the SIR lead wire to the clip on the steering wheel.
- Install the SIR lead wire to the clip on the inflator module.
- Press the inflator module into the steering wheel firmly enough that the module engages and latches the notched pins in the leaf springs.
- Rotate the steering wheel back into the straight position.
- Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .
- Connect the battery negative cable.
IMPORTANT:
Ensure that the SIR wires do not get pinched during installation of the inflator module.