LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Jimmy Part Time, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Brake Pressure Modulator Valve (BPMV) Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Locating Electronic Brake Control Module Components
    GM550743Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
  1. Install EBCM (2) onto BPMV (3).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Do not reuse the old mounting bolts. Always install new bolts with the new BPMV.
  2. Install the four EBCM bolts.

    Tighten:  Tighten the four bolts to 5 N.m (39 lb in) in an X-pattern.

  3. Connect the 2 way ABS pump motor connector to the EBCM (2).
  4. Install BPMV (3) to EHCU bracket (5).
  5. Connect the two electrical harness connectors to the EBCM (2).
    6. IMPORTANT: The brake pipes are held in the proper place by a frame mounted plastic bracket. Make sure that the brake pipes stay in the correct place for proper reassembly.
  6. Install the 5 brake pipes to the BPMV (3).

    Tighten:  Tighten the brake pipe fittings to 30 N.m (22 lb ft).

  7. Bleed the brake system. Refer to ABS Automated Bleed Procedure .
scientia non olet · About LEMON Manuals