LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Jimmy Part Time, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Repair Instructions >> Cruise Control Cable Replacement (LU3) >> Installation Procedure

Installation Procedure

  1. Install the cruise control cable to the vehicle.
    2. Fig 1: Identifying Twisted Ribbon
    GM293672Courtesy of GENERAL MOTORS CORP.
  2. Remove all bends and twists from the cruise control module ribbon and cable, by rotating until removed.
    3. Fig 2: View Of Cruise Control Cable At Cruise Control Module Housing
    GM597101Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • Do not twist the cruise control module ribbon (1).
    • Pull the cruise control cable (2) to verify retention to the ribbon (1).
  3. Attach the cruise control cable bead (2) to the cruise control module ribbon (1).
    4. Fig 3: Inspecting Orientation Of Cruise Control Ribbon Buckle
    GM293695Courtesy of GENERAL MOTORS CORP.
  4. Check the orientation of the cruise control ribbon buckle to the cable end fitting.
    5. Fig 4: Sliding Cruise Control Cable Conduit Over Ribbon
    GM487408Courtesy of GENERAL MOTORS CORP.
  5. Slide the cruise control cable conduit over the ribbon.
    1. Install the tangs to the cruise control module housing.
    2. Ensure that the tangs snap securely into place.
    6. Fig 5: Connecting Cruise Control Cable End To Throttle Linkage
    GM580222Courtesy of GENERAL MOTORS CORP.
  6. Snap the cruise control cable engine-end fitting (2) over the stud (1) on the throttle cam lever.
    7. Fig 6: View Of Cruise Control Cable At Round Hole In Engine Cable Bracket
    GM580230Courtesy of GENERAL MOTORS CORP.
  7. Connect the cruise control cable conduit fitting to the round hole in the engine cable bracket.

    Ensure that the tabs snap securely into the hole.

    8. Fig 7: View Of Cruise Control Cable Locator Clip At Rectangular Hole In Routing Bracket
    GM597198Courtesy of GENERAL MOTORS CORP.
  8. Connect the cruise control cable locator clip to the rectangular hole in the routing bracket.
    1. Route the cruise control cable above the accelerator cable.
    2. Ensure that the clip snaps securely into place.
    9. Fig 8: View Of Electrical Connection To Cruise Control Servo Module
    GM418780Courtesy of GENERAL MOTORS CORP.
  9. Connect the electrical connection to the cruise control servo module.
  10. Test the systems operation.
  11. Perform the Cruise Control System Functional Test. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
  12. Close hood.
scientia non olet · About LEMON Manuals