LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Jimmy Part Time, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Introduction & Repair Instructions >> Repair Instructions >> Control and Shift Solenoids Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of 3-2 Control Solenoid & Retainer
    GM298167Courtesy of GENERAL MOTORS CORP.
  1. Install the 3-2 control solenoid.
  2. Install the 3-2 control solenoid retainer.
    3. Fig 2: View Of 1-2 & 2-3 Shift Solenoids & Retainers
    GM298169Courtesy of GENERAL MOTORS CORP.
  3. Install the 1-2 and 2-3 shift solenoids.
  4. Install the 1-2 and 2-3 shift solenoid retainers.
    5. Fig 3: Locating Pressure Control Solenoid & Retainer
    GM298162Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the pressure control solenoid.

    Ensure that the electrical tabs are facing outboard.

  6. Install the pressure control solenoid retainer and retaining bolt.

    Tighten:  Tighten the pressure control solenoid retaining bolt to 11 N.m (97 lb in).

    7. Fig 4: Identifying Valve Body Electrical Connections
    GM181573Courtesy of GENERAL MOTORS CORP.
  7. Connect the internal wiring harness electrical connectors to the following components:
    • Transmission fluid pressure switch (1)
    • 1-2 shift control solenoid (2)
    • 2-3 shift control solenoid (3)
    • Pressure control solenoid (4)
    • TCC PWM solenoid (5)
    • 3-2 control solenoid (6)
  8. Install the 1-2 accumulator. Refer to Accumulator Assembly, Spacer Plate, and Gaskets .
  9. Install the transmission oil pan and filter. Refer to Automatic Transmission Fluid/Filter Replacement .
  10. Fill the transmission to the proper level with DEXRON® III transmission fluid. Refer to Transmission Fluid Checking Procedure .
scientia non olet · About LEMON Manuals