LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Jimmy Part Time, Automatic >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing Steering Wheel
    GM395779Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the turn signal on the multifunction switch is in the neutral position when installing the steering wheel.
  1. Align the mark on the steering wheel and the steering shaft.
  2. Install the steering wheel to the steering shaft.
    3. Fig 2: View Of Steering Wheel
    GM395774Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the steering wheel retaining nut to the steering shaft.

    Tighten:  Tighten the nut to 41 N.m (30 lb ft).

    4. Fig 3: View Of Steering Wheel Electrical Connector
    GM395777Courtesy of GENERAL MOTORS CORP.
  4. On vehicles with redundant steering wheel controls, connect the steering wheel electrical connector.
    5. Fig 4: View Of Horn Plunger At Steering Column
    GM399638Courtesy of GENERAL MOTORS CORP.
  5. Install the horn plunger to the steering column.
  6. Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals