LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2005 >> Jimmy Part Time, Automatic >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle (CB Series) >> Assembly Procedure

Assembly Procedure

    Fig 1: Removing Control Valve Assembly & Flow Control Spring
    GM448001Courtesy of GENERAL MOTORS CORP.
  1. Install the flow control spring (2) to the pump housing assembly (1).
  2. Install the control valve assembly (3) to the flow control spring (2).
    3. Fig 2: Removing O-Ring Seal, Connector & Fitting Assembly
    GM448006Courtesy of GENERAL MOTORS CORP.
  3. Lubricate the O-ring seal (3) with power steering fluid.
  4. Install the O-ring seal (3).
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the connector and fitting assembly (3) to the pump housing (1).

    Tighten:  Tighten the connector and fitting assembly (3) to 75 N.m (55 lb ft).

scientia non olet · About LEMON Manuals