LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Sierra 2500 HD, 2D Pickup, 6.6 2, RWD, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 6.6L (LLY) (Introduction) >> Repair Instructions >> Boost Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

  1. Position the boost sensor onto the bracket.
    Fig 1: View Of Boost Sensor Bracket Bolt
    GM1412235Courtesy of GENERAL MOTORS CORP.
  2. Install the boost sensor and bracket.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the boost sensor bracket bolt (1).

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  4. Install the right fuel rail fuel feed pipe. Refer to Fuel Rail Fuel Feed Pipe Replacement - Right .
scientia non olet · About LEMON Manuals