LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Bracket Replacement (4.3L) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Generator Mounting Bracket
    GM196643Courtesy of GENERAL MOTORS CORP.
  1. Install the generator mounting bracket to the cylinder head.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 2 generator mounting bracket bolts and the nut.

    Tighten:  Tighten the generator mounting bracket bolts and nut to 41 N.m (30 lb ft).

  3. Install the drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement - Right in Engine Mechanical - 4.3L.
  4. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement in Engine Mechanical - 4.3L.
    5. Fig 2: Locating Engine Wiring Harness Bracket
    GM340790Courtesy of GENERAL MOTORS CORP.
  5. Install the engine wiring harness bracket to the generator mounting bracket.

    Tighten:  Tighten the engine wiring harness bracket bolt to 25 N.m (18 lb ft).

  6. Install the generator. Refer to Generator Replacement (4.3L) .
  7. Install the drive belt. Refer to Drive Belt Replacement in Engine Mechanical - 4.3 L.
  8. Install the engine cooling fan. Refer to Fan Clutch Replacement in Engine Cooling.
  9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
scientia non olet · About LEMON Manuals