Installation Procedure

IMPORTANT: Ensure the ignition coil seals are properly seated to the camshaft cover.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the ignition coil bolts.
Tighten: Tighten the ignition coil bolts to 10 N.m (89 lb in).

Fig 1: View Of Ignition Coil

Courtesy of GENERAL MOTORS CORP.

Fig 2: View Of Engine Wiring Harness Conduit

Courtesy of GENERAL MOTORS CORP.

Connect the engine wiring harness electrical connectors to the following:
- The ECT sensor (1)
- The fuel injector harness (2)
- The ignition coils (4)
- The HO2S (5)

Fig 3: View Of ECT Sensor, Fuel Injector, Ignition Coil & HO2S Engine Wiring Harness Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the engine wiring harness electrical connectors (1, 4) to the following:
- The CMP sensor (5)
- The CMP actuator solenoid valve (6)
Connect the engine wiring harness retainer (2) to the camshaft cover (3).

Fig 4: View Of CMP Sensor Connector, Exhaust Camshaft Actuator Connector & Engine Wiring Harness Retainer

Courtesy of GENERAL MOTORS CORP.

Fig 5: View Of Power Steering Pump Engine Wiring Harness Retainers

Courtesy of GENERAL MOTORS CORP.

Connect the engine wiring harness electrical connector (2) to the oil pressure sensor (1).
Connect the engine wiring harness retainer (3) to the oil filter adapter (4).

Fig 6: View Of Engine Wiring Harness At Oil Pressure Sensor & Oil Filter Adapter

Courtesy of GENERAL MOTORS CORP.

Install the air cleaner resonator and outlet duct. Refer to Air Cleaner Resonator and Outlet Duct Replacement .