LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Canyon 2D Pickup, 2.8 8, RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System - 3.5L (Introduction)) >> Repair Instructions >> Powertrain Control Module (PCM) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the PCM into the PCM mounting bracket, allowing the tabs to fully engage.
    2. Fig 1: View Of PCM
    GM1352004Courtesy of GENERAL MOTORS CORP.
  2. Connect the PCM harness connectors (2) to the PCM body (3).
    3. Fig 2: View Of PCM & Harness Connectors
    GM1350711Courtesy of GENERAL MOTORS CORP.
  3. If a new PCM is being installed, the PCM must be programmed. Refer to Service Programming System (SPS) in Programming.
  4. Perform the crankshaft position (CKP) system variation learn procedure. Refer to CKP System Variation Learn Procedure or to CKP System Variation Learn Procedure .
scientia non olet · About LEMON Manuals