LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Canyon 2D Pickup, 2.8 8, RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System - 3.5L (Introduction)) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Position the air cleaner assembly into the engine compartment, inserting the snorkel (2) into the fender (1).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 2 bolts (3) and nut (5) securing the air cleaner assembly to the wheel house (4).

    Tighten: 

    • Tighten the air cleaner assembly bolts to 10 N.m (89 lb in).
    • Tighten the air cleaner assembly nut to 15 N.m (11 lb ft).

  3. Connect the air cleaner outlet duct to the air cleaner assembly.

    Tighten:  Tighten the air cleaner outlet duct clamp to 6 N.m (53 lb in).

    4. Fig 1: View Of Air Cleaner Assembly
    GM1352017Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
    5. Fig 2: View Of MAF/IAT Sensor
    GM1352006Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals