LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Canyon 2D Pickup, 2.8 8, RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System - 3.5L (Introduction)) >> Repair Instructions >> Accelerator Pedal Position (APP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Position the APP sensor over the studs.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the APP sensor nuts.

    Tighten:  Tighten the APP sensor mounting nuts to 9 N.m (80 lb in).

  3. Connect the APP sensor electrical connector.
  4. Inspect below the pedal for binding, to ensure full range of motion.
    5. Fig 1: View Of APP Sensor
    GM1352013Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals