LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Canyon 2D Pickup, 2.8 8, RWD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.8L (Introduction) >> Repair Instructions >> Quick Connect Fitting(s) Service (Plastic Collar) >> Installation Procedure

Installation Procedure

    CAUTION: Refer to Fuel Pipe Fitting Caution in Cautions and Notices.
  1. Apply a few drops of clean engine oil to the male pipe end.
    2. Fig 1: Lubricating Male Pipe End
    GM155425Courtesy of GENERAL MOTORS CORP.
  2. Push both sides of the quick-connect fitting together in order to cause the retaining feature to snap into place.
    3. Fig 2: Connecting Quick-Connect Fittings
    GM21855Courtesy of GENERAL MOTORS CORP.
  3. Pull on both sides of the quick-connect fitting to make sure the connection is secure.
    4. Fig 3: Ensuring Secure Connection
    GM155399Courtesy of GENERAL MOTORS CORP.
  4. Inspect for leaks using the following procedure:
    1. Turn the ignition ON, with the engine OFF for 2 seconds.
    2. Turn the ignition OFF, for 10 seconds.
    3. Turn the ignition ON, with the engine OFF for 2 seconds.
    4. Turn the ignition OFF.
    5. Inspect for leaks.
scientia non olet · About LEMON Manuals