LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Canyon 2D Pickup, 2.8 8, RWD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.8L (Introduction) >> Repair Instructions >> Fuel Filler Hose Replacement >> Removal Procedure

Removal Procedure

  1. Partially drain the fuel tank below the level of the fuel filler hose. Refer to Fuel Tank Draining Procedure .
  2. Raise and support the vehicle, high enough to access the fuel filler hose through the wheelhouse liner. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the left pickup box wheelhouse liner. Refer to Pickup Box Wheelhouse Liner Replacement in Body Rear End.
  4. Remove the bolt (3) securing the fuel filler hose ground strap to the frame (2).
    5. Fig 1: Locating Fuel Filler Hose Ground Strap & Bolt
    GM1361728Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the fuel filler hose (4) from the fuel tank (3).
  6. Disconnect the evaporative emission (EVAP) hose (2) from the filler vent tube (1). Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    7. Fig 2: View Of EVAP Hose & Fuel Filler Hose
    GM1361710Courtesy of GENERAL MOTORS CORP.
  7. Remove the fuel filler hose screws.
  8. Remove the fuel filler hose from the vehicle.
    9. Fig 3: View Of Fuel Filler Hose
    GM1361727Courtesy of GENERAL MOTORS CORP.
  9. Cap the open end of the fuel tank.
scientia non olet · About LEMON Manuals