LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Canyon 2D Pickup, 2.8 8, RWD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.8L (Introduction) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the engine wiring harness electrical connector (3) from the crankshaft position (CKP) sensor (1).
    3. Fig 1: View Of CKP Sensor & Components
    GM1350744Courtesy of GENERAL MOTORS CORP.
  3. Remove the CKP sensor bolt.
  4. Remove the CKP sensor from the engine block.

    Discard the O-ring seals.

    5. Fig 2: View Of CKP Sensor
    GM858202Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals