LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Canyon 2D Pickup, 2.8 8, RWD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.8L (Introduction) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure

Installation Procedure

  1. Install new O-ring seals to the CKP sensor.
  2. Lightly lubricate the O-ring seals with clean engine oil.
  3. Install the CKP sensor into the engine block.
  4. Add sealer GM P/N 12346004 (Canadian P/N 10953480) to the CKP sensor bolt threads.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the CKP sensor bolt.

    Tighten:  Tighten the crankshaft position (CKP) sensor bolt to 10 N.m (89 lb in).

    6. Fig 1: View Of CKP Sensor
    GM858202Courtesy of GENERAL MOTORS CORP.
  6. Connect the engine wiring harness electrical connector (3) to the CKP sensor (1).
    7. Fig 2: View Of CKP Sensor & Components
    GM1350744Courtesy of GENERAL MOTORS CORP.
  7. Lower the vehicle.
  8. Perform the crankshaft (CKP) system variation learn procedure. Refer to CKP System Variation Learn Procedure .
scientia non olet · About LEMON Manuals