LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Canyon 2D Pickup, 2.8 8, RWD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.8L (Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the engine wiring harness electrical connector (4) from the camshaft position (CMP) sensor (5).
    2. Fig 1: View Of CMP Sensor Connector, Exhaust Camshaft Actuator Connector & Engine Wiring Harness Retainer
    GM1350714Courtesy of GENERAL MOTORS CORP.
  2. Remove the CMP sensor retaining bolt.
  3. Remove the CMP sensor from the cylinder head.

    Discard the O-ring seal.

    4. Fig 2: View Of CMP Sensor
    GM858172Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals