LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Canyon 2D Pickup, 2.8 8, 4WD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.8L (Introduction) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

  1. Insert a new seal into the intake manifold groove.
  2. Position the throttle control module (2) to the intake manifold.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the throttle control module bolts (1).

    Tighten:  Tighten the throttle control module bolts to 10 N.m (89 lb in).

    4. Fig 1: View Of Throttle Control Module
    GM742490Courtesy of GENERAL MOTORS CORP.
  4. Connect the throttle control module electrical connector (2).
    5. Fig 2: View Of Throttle Control Module Electrical Connector
    GM1350717Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP canister purge pipe (1) to the throttle control module (2). Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    6. Fig 3: View Of EVAP Canister Purge Pipe, Throttle Body Module & EVAP Canister Purge Solenoid Valve
    GM1352026Courtesy of GENERAL MOTORS CORP.
  6. Install the air cleaner resonator and outlet duct. Refer to Air Cleaner Resonator and Outlet Duct Replacement .
scientia non olet · About LEMON Manuals