LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Canyon 2D Pickup, 2.8 8, 4WD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.8L (Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

  1. Install a new O-ring seal to the CMP sensor.
  2. Lightly lubricate the O-ring seal with clean engine oil.
  3. Install the CMP sensor into the cylinder head.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the CMP sensor bolt.

    Tighten:  Tighten the camshaft position (CMP) sensor bolt to 10 N.m (89 lb in).

    5. Fig 1: View Of CMP Sensor
    GM858172Courtesy of GENERAL MOTORS CORP.
  5. Connect the engine wiring harness electrical connector (4) to the CMP sensor (5).
    6. Fig 2: View Of CMP Sensor Connector, Exhaust Camshaft Actuator Connector & Engine Wiring Harness Retainer
    GM1350714Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals