LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2004 >> Canyon 2D Pickup, 2.8 8, 4WD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 2.8L (Introduction) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Installation Procedure

Installation Procedure

  1. Position the air cleaner assembly into the engine compartment, inserting the snorkel (2) into the fender (1).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 2 bolts (3) and nut (5) securing the air cleaner assembly to the wheel house (4).

    Tighten: 

    • Tighten the air cleaner assembly bolts to 10 N.m (89 lb in).
    • Tighten the air cleaner assembly nut to 15 N.m (11 lb ft).

    3. Fig 1: View Of Air Cleaner Assembly
    GM1352017Courtesy of GENERAL MOTORS CORP.
  3. Connect the air cleaner outlet duct to the air cleaner assembly.

    Tighten:  Tighten the air cleaner outlet duct clamp to 6 N.m (53 lb in).

  4. Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
    5. Fig 2: View Of MAF/IAT Sensor Electrical Connector
    GM1352006Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals