Cleaning Procedures
WARNING: This page is about a different variant/trim than selected.
- Disconnect negative battery cable.
- Remove fuel sending unit assembly.
- Inspect fuel strainer. Replace a contaminated strainer and inspect fuel pump.
- Inspect fuel pump inlet for dirt and debris. Replace fuel pump if you find dirt or debris in fuel pump inlet.
- Flush fuel tank with hot water.
- Pour water out of fuel sender assembly opening.
- Rock the tank to be sure that removal of the water from tank is complete.
- Install sending unit.
NOTE:
When flushing fuel tank, handle fuel and water mixture as a hazardous material. Handle fuel and water mixture in accordance with all applicable local, state and federal laws and regulations.