Flow Check
NOTE:
The Flow Check must be performed after the flush to ensure that all flushing solution and water is removed from the oil cooling system.
- Disconnect both hoses from the oil cooler pipes. Connect the oil cooler feed pipe, bottom connector, to the transmission for normal flow.
- Clip the discharge hose (5) onto the empty oil drain container. See Fig 1.
- Confirm the transmission is filled with ATF. See CHECKING FLUID LEVELS .
- Start the engine with the transmission in Park range and run for 30 seconds. A minimum of 2 qts. (1.9L) must be discharged during this 30-second run time.
- If the fluid flow meets or exceeds 2 qts. (1.9L) in 30 seconds, connect the oil cooler feed pipe to the bottom connector on the transmission.
- If fluid flow is less than 2 qts. (1.9L) in 30 seconds, perform the following diagnosis:
- Disconnect the discharge hose (5) from the oil cooler return pipe.
- Disconnect the oil cooler feed line at the radiator.
- Connect the discharge hose (5) to the cooler feed line.
- Clip the discharge hose (5) to the empty oil drain container.
- Start the engine with the transmission in Park range and run for 30 seconds. A minimum of 2 qts. (1.9L) must be discharged during this 30-second run time.
- If the amount of transmission fluid flow remains less than 2 qts. (1.9L) in 30 seconds, inspect the oil cooler feed pipe, bottom connector, for restrictions or damage. If no condition is found with the feed pipe, bottom connector, inspect the transmission.