LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle (CB Series) >> Assembly Procedure

Assembly Procedure

  1. Install the flow control spring (2) to the pump housing assembly (1).
  2. Install the control valve assembly (3) to the flow control spring (2).
    Fig 1: Installing Control Valve Assembly & Flow Control Spring To Pump Housing Assembly
    G01467175Courtesy of GENERAL MOTORS CORP.
  3. Lubricate the O-ring seal (3) with power steering fluid.
  4. Install the O-ring seal (3).
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the connector and fitting assembly (3) to the pump housing (1).

    Tighten 

    Tighten the connector and fitting assembly (3) to 75 N.m (55 lb ft).

Fig 2: Installing Connector & O-Ring Seal To Pump Housing
G01467176Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals