LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (Wiring Systems - Specifications, Component Views And Connector End Views) >> Repair Instructions >> Instrument Panel Electrical Center or Junction Block Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Bracket To Electrical Wiring Junction Block
    GM820741Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the right door sill plate. Refer to Door Sill Plate Replacement in Interior Trim.
  3. Remove the floor kick-up pad on the passenger side. Refer to Kick-Up Panel Replacement - Front Floor in Interior Trim.
  4. Remove the retaining bolt which secures the multi-use bracket to the electrical wiring junction block.
    5. Fig 2: 64-Way Block Connectors & 3 I/P Wiring Harness Connectors
    GM820742Courtesy of GENERAL MOTORS CORP.
  5. Disengage the retaining clip from the outboard side, twist the electrical wiring block, and pull outward.
  6. Remove the battery cable lead.
  7. Disconnect 3 64-way block connectors and 3 I/P wiring harness connectors.
  8. Transfer all fuses and relays as required.
scientia non olet · About LEMON Manuals