LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics - 4.3L >> Diagnostic Tests >> DTC P0443: EVAP Purge Solenoid Control Circuit >> Test Description

Test Description

The numbers below refer to the step numbers in the diagnostic procedures.

  1. 2 -  This step tests if the concern is active. The EVAP purge solenoid is PWM. You should hear a clicking sound when the purge solenoid is commanded to 50 percent. The clicking sound should stop when the EVAP purge solenoid is commanded to zero percent. The rate at which the valve cycles should increase when the commanded state is increased, and decrease when the commanded state is decreased. Repeat the commands as necessary.
  2. 5 -  This step verifies that the control module is providing ground to the EVAP purge valve.
  3. 6 -  This step tests if a ground is constantly being applied to the EVAP purge valve.

scientia non olet · About LEMON Manuals