Throttle Body: Notes
CAUTION:
Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.
CAUTION:
DO NOT subject a throttle body assembly to an immersion cleaner or a strong solvent with electrical components or sensors attached. Solvents can also wash away or break down the grease used on non-serviceable throttle shaft bearings. DO NOT use a cleaner containing Methyl Ethyl Ketone (MEK). MEK is very strong and can damage components. Never use a wire brush or scraper to clean the throttle body. A wire brush or sharp tools may damage throttle body components.