LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Safari Van Passenger, RWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls Removal & Installation >> Torque Specifications

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Battery Cable-To-Battery Bolt 11 (15)
Distributor Hold-Down Bolt 18 (25)
Engine Coolant Temperature Sensor 15 (20)
Engine Cover-To-Firewall Bolts 18 (25)
Fuel Filter Fuel Line Fittings 20 (27)
Fuel Tank Strap Retaining Bolts 26 (35)
Knock Sensor Retaining Bolt 18 (25)
Oxygen Sensor 31 (42)
Spark Plugs (1)
Steering Linkage Shield Mounting Bolts 24 (33)
Upper Intake Manifold Retaining Studs (2)
INCH Lbs. (N.m) 
Accelerator Control Cable Bracket-To-Throttle Body And Intake Manifold Studs/Nuts 106 (12.0)
A/C Hose Bracket-To-Intake Manifold Stud Retaining Nut 44 (5.0)
Air Cleaner Outlet Duct Adapter Stud 71 (8.0)
Air Cleaner Outlet Duct-To-MAF Sensor Clamp 35 (4.0)
Camshaft Position Sensor Screws 18 (2.0)
Crankshaft Position Sensor Bolt 80 (9.0)
Distributor Cap Screws 21 (2.4)
Distributor Rotor Screws 18 (2.0)
Engine Cover Bracket-To-Floor Bolts 35 (4.0)
Engine Wiring Harness Bracket-To-Intake Manifold Stud Retaining Nut (Left Side Of Engine) 106 (12.0)
Engine Wiring Harness Bracket-To-Intake Manifold Stud Retaining Nut (Right Side Of Engine) 71 (8.0)
EVAP Canister Purge Solenoid Mounting Nuts 106 (12.0)
EVAP Canister Vent Valve Mounting Bolt 89 (10.0)
Fuel Filter Mounting Clamp Bolt 97 (11.0)
Idle Air Control Valve Screws 27 (3.0)
Ignition Coil Mounting Studs 97 (11.0)
Ignition Control Module Retaining Screws 31 (3.5)
Injector Retainer Lock Nuts 27 (3.0)
PCM Harness Connector Fasteners 71 (8.0)
Throttle Body Unit-To-Intake Manifold Studs 80 (9.0)
Throttle Position Sensor Bolts 18 (2.0)
Transmission Fluid Filler Tube-To-Accelerator Control Cable Bracket Retaining Bolt 53 (6.0)
(1) If cylinder heads have not been replaced, tighten spark plugs to 11 ft. lbs. (15 N.m). With NEW aluminum cylinder heads, tighten spark plugs to 15 ft. lbs. (20 N.m). With NEW iron cylinder heads, tighten spark plugs to 22 ft. lbs. (30 N.m).
(2) Tighten studs incrementally to 44 INCH lbs. (5 N.m), and then fully to 80 INCH lbs. (9 N.m).