LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Jimmy 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Flow Control Valve Replacement - Off Vehicle (CB Series) >> Assembly Procedure

Assembly Procedure

  1. Install the flow control spring (2) to the pump housing assembly (1).
  2. Install the control valve assembly (3) to the flow control spring (2).
    Fig 1: Installing Flow Control Spring & Control Valve Assembly (CB Series)
    G01669855Courtesy of GENERAL MOTORS CORP.
  3. Lubricate the O-ring seal (3) with power steering fluid.
  4. Install the O-ring seal (3).
    NOTE: Refer to FASTENER NOTICE .
  5. Install the connector and fitting assembly (3) to the pump housing (1).

    Tighten 

    Tighten the connector and fitting assembly (3) to 75 N.m (55 lb ft).

    Fig 2: Installing O-Ring Seal & Connector/Fitting Assembly (CB Series)
    G01669856Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals