LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1418 (Engine Control System - 4.2L (Introduction)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing CMP Sensor
    GM487648Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the camshaft position (CMP) sensor.

    Tighten:  Tighten the CMP sensor bolt to 10 N.m (89 lb in).

  2. Install the CMP sensor electrical connector (1).
scientia non olet · About LEMON Manuals