LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1405 (Cellular Communication System) >> Repair Instructions >> Navigation Control Processor Bracket Replacement (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Processor Bracket
    GM742195Courtesy of GENERAL MOTORS CORP.
  1. Install the processor bracket to the rear seat studs.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nut to the rear seat back stud.

    Tighten:  Tighten the nut to 45 N.m (33 lb ft).

    3. Fig 2: Identifying Retaining Tab
    GM741626Courtesy of GENERAL MOTORS CORP.
  3. Position the upper bracket to the processor bracket.
  4. Slide the upper bracket outboard until all the retaining tabs are seated to the processor bracket.
  5. Install the communication interface module. Refer to Communication Interface Module Replacement (TrailBlazer, Envoy, Bravada)  or Communication Interface Module Replacement (TrailBlazer EXT, Envoy XL)  in Interior Trim.
  6. Install the right rear seat cushion. Refer to Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) in Seats.
scientia non olet · About LEMON Manuals