LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1513 (Wiring Systems - Specifications, Component Views And Connector End Views) >> Repair Instructions >> Underhood Electrical Center or Junction Block Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: IP Wiring Harness Connector To Junction Block
    GM821474Courtesy of GENERAL MOTORS CORP.
  1. Connect the IP wiring harness connector to the junction block.
  2. Connect the engine wiring harness connector to the junction block.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the underhood junction block connector bolts.

    Tighten:  Tighten the underhood junction block connector bolts to 7 N.m (62 lb in).

  4. Turn the electrical center right side up.
  5. Connect the electrical cable retainers at the rear of the junction block.
    6. Fig 2: Cable Lead To Junction Block
    GM821475Courtesy of GENERAL MOTORS CORP.
  6. Install the junction block cover.
  7. Install the positive battery cable lead to the junction block stud. Install the positive battery cable lead nut.

    Tighten:  Tighten the positive battery cable lead nut to 10 N.m (89 lb in).

  8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About LEMON Manuals