Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Inspect the sensor O-ring for the following conditions:

Any wear
Any cracks
Any leakage

Replace the O-ring if necessary. Lubricate the new 0-ring with engine oil before installation.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: Removing/Installing CKP Sensor

Courtesy of GENERAL MOTORS CORP.

Install the CKP sensor into the engine block.
Tighten: Tighten the bolt to 10 N.m (89 lb in).
Install the CKP sensor retaining bolt.
Connect the CKP sensor harness connector.
Lower the vehicle.
Perform the CKP System Variation Learn Procedure .