Crankshaft Position Sensor: Installation

Install CKP sensor into engine using NEW "O" ring. Tighten CKP sensor mounting bolt to specification. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure. Perform CRANKSHAFT POSITION (CKP) SENSOR VARIATION LEARN PROCEDURE in COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION.

1. Ensure CKP sensor mounting surface is clean and free of burrs. Using a NEW CKP sensor "O" ring lubricated with clean engine oil, install CKP sensor into timing cover.
2. Ensure CKP sensor is fully seated into timing cover before tightening mounting bolt. A poorly seated CKP sensor may perform erratically and may set false DTCs. Install CKP sensor mounting bolt and tighten to specification. See TORQUE SPECIFICATIONS .
3. Reconnect CKP sensor harness connector. Install steering linkage shield and tighten mounting bolts to specification (if equipped). Lower vehicle. Perform CRANKSHAFT POSITION (CKP) SENSOR VARIATION LEARN PROCEDURE in COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION.