Intake Manifold: Installation

To install, reverse removal procedure. Tighten intake manifold bolts and nuts to specification using an alternating sequence. See Fig 5. See TORQUE SPECIFICATIONS . When installing engine wiring harness bracket, tighten the 2 engine wiring harness bracket-to-valve cover bolts to specification first, followed by the engine wiring harness bracket-to-cylinder head bolt. See Fig 3.

Fig 1: Removing/Installing Wheelwell Extension (Sonoma & S10 Pickup)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Removing/Installing Rear Generator Brace (2.2L)

Courtesy of GENERAL MOTORS CORP.

Fig 3: Removing/Installing Engine Wiring Harness Bracket (2.2L)

Courtesy of GENERAL MOTORS CORP.

Fig 4: Removing/Installing Intake Manifold (2.2L)

Courtesy of GENERAL MOTORS CORP.

Fig 5: Identifying Intake Manifold Tightening Sequence (2.2L)

Courtesy of GENERAL MOTORS CORP.

To install, reverse removal procedure. Tighten fasteners to specification. See TORQUE SPECIFICATIONS . Tighten upper intake manifold retaining studs to specification using an alternating sequence.

Fig 1: Removing/Installing Accelerator Control Cable Bracket (4.3L)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Removing A/C Hose & Engine Wiring Harness Brackets From Intake Manifold (4.3L)

Courtesy of GENERAL MOTORS CORP.

Fig 3: Removing Engine Wiring Harness Bracket Near EVAP Canister Purge Solenoid (4.3L)

Courtesy of GENERAL MOTORS CORP.