LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Jimmy 2D Utility, Automatic, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Shift Interlock Systems) >> Removal & Installation >> Floor Shift Control Cable >> Installation

Floor Shift Control Cable: Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Push the cable down through the floor panel and install the grommet (2). See Figure . Install the range selector cable (2) to the floor shift control assembly. See Figure .
  2. Install the end of the range selector cable (1) to floor control ball stud. Install the drivers side front mat and carpet. Install the console. See FLOOR CONSOLE  .
  3. Raise and support the vehicle. Install the cable to the retainer (3) on the floor panel. See Figure . If the vehicle is equipped with 4WD, install the cable to the retainers located on the transfer case.
  4. On all models, install the range selector cable (4) to the bracket (1). Install the retainer (5) to the range selector cable. Install the end of the range selector cable to the transmission range selector lever ball stud (6). Adjust the range selector cable. Lower the vehicle and check for proper operation.
scientia non olet · About LEMON Manuals