LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Jimmy 2D Utility, Automatic, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1491 (Front Suspension System) >> Repair Instructions >> Shock Module Yoke Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shock module yoke to the lower control arm stud and shock absorber.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the shock module yoke to shock absorber pinch bolt and nut.

    Tighten 

    Tighten the shock module yoke to shock absorber pinch bolt to 70 N.m (52 lb ft).

    Fig 1: Installing Shock Module Yoke To Shock Absorber Pinch Bolt And Nut
    G01597396Courtesy of GENERAL MOTORS CORP.
  3. Install the shock module yoke to lower control arm mounting nut.

    Tighten 

    Tighten the shock module yoke to lower control arm mounting nut to 110 N.m (81 lb ft).

  4. Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION  in Tires and Wheels.
  5. Lower the vehicle.
    Fig 2: Installing Shock Module Yoke To Lower Control Arm Mounting Nut
    G01597397Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals