Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Video Player Front Bracket Locating Tabs

Courtesy of GENERAL MOTORS CORP.

Carefully install the bracket to the vehicle through the headliner opening, ensuring the locating tabs (1) are fully seated to the roof bow.
Partially install the front bracket retaining bolts.

Fig 2: Removing/Installing Video Player Front Bracket Retaining Bolts
Courtesy of GENERAL MOTORS CORP.
Carefully pull down on the rearward edge of the headliner in order to expose the rear bolt installation area.

Fig 3: Locating Video Player Rear Bracket Retaining Bolt
Courtesy of GENERAL MOTORS CORP.
Partially install the rear bracket retaining bolt.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Fully seat the retaining bolts.
Tighten: Tighten the bolts to 10 N.m (88 lb in).
Install the two rear overhead console carrier screws (1).
Tighten: Tighten the screws to 1.2 N.m (10 lb in).

Fig 4: Identifying Rear Overhead Console Carrier Screws
Courtesy of GENERAL MOTORS CORP.
Install the video display assembly. Refer to Video Display Replacement .
Verify the video display for proper operation.
Close the video display screen.
Install the bolt cover bezel.