LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Jimmy 2D Utility, Automatic, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1372 (Front Suspension System) >> Repair Instructions >> Strut Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
    3. Fig 1: Strut Bracket, Stabilizer Shaft Links And 6 mm Wrench
    GM821347Courtesy of GENERAL MOTORS CORP.
  3. Use a wrench in order to hold the front stabilizer shaft link stud. Remove the nut and the stud from the bracket (1) in order to separate the link (3) from the strut.
  4. If the vehicle has ABS, remove the ABS wheel speed sensor from the steering knuckle. Position the sensor to the side. Refer to Wheel Speed Sensor Replacement - Front in Antilock Brake System.
    5. Fig 2: Front Brake Hose Bolt, Brake Hose And Strut
    GM821349Courtesy of GENERAL MOTORS CORP.
  5. Remove the front brake hose bolt (1) and the hose from the bracket on the strut. Position the hose and the bolt to the side.
    6. Fig 3: Strut Assembly Nuts And Bolts
    GM821091Courtesy of GENERAL MOTORS CORP.
  6. Loosen the 2 nuts (3,4) on the lower side of the strut assembly. Do not remove the bolts.
  7. Partially lower the vehicle.
  8. Remove the 3 nuts from the top of the strut.
  9. Remove the 2 nuts and the 2 bolts (1,2) from the lower side of the strut.
  10. Remove the strut assembly from the vehicle.
scientia non olet · About LEMON Manuals